* Condition and roll the clay to desired thickness. I like a sheet about 1.4 inch. Gently roll your clay over the paper, stamp with your stamp, or press onto texture plate. You may need a bit of release agent to keep the clay from...
See more »
* Condition and roll the clay to desired thickness. I like a sheet about 1.4 inch. Gently roll your clay over the paper, stamp with your stamp, or press onto texture plate. You may need a bit of release agent to keep the clay from sticking. You can use mica powders, glitter or eye shadows to enhance the effect and act a release agent. * Remove the clay sheet from the surface, and cut as desired. I used a circle cookie cutter, but you can free hand it to. Let the clay rest a bit to make avoid distorting the piece when you insert the wire. Trip the eye pin so it will go to about the middle of your pendant. Gently push the wire into the pendant, making a hole. Remove the wire. Bake per your clays instructions. Sand and Finish as desired. After the piece is finished, put a dab of glue or epoxy on the eye pin and insert into the hole. Let dry fully before wear.
See less »
Kaboodle will send you a newsletter and updates from your friends. You can unsubscribe at any time. Kaboodle does not sell or share your email address or personal information with anyone.
Kaboodle requires all users to provide their real date of birth as both a safety precaution and as a means
of preserving the integrity of the site. You will be able to hide this information from your profile if you wish.
Added by 1 people